Watain Disciples Worldwide | Trident Divider

Vest Etiquette

This is the official and required vest etiquette for all Watain Disciples.

Watain Disciples Worldwide | Trident Divider

The Watain Vest

Patches only to be worn by members of Watain.

The Member Vest

To be worn by members of the Watain Disciples.

The Division Vest

To be worn by members within Divisions of the Watain Disciples.

Watain Disciples Worldwide | Trident Divider

Patch Information

More information on vest layout, additions, patches and Division guidelines.

E. Has Made It Very Clear

“It is important to point out that the designs shouldn’t say "WATAIN" only, but always "WATAIN DISCIPLES" and Division name, in order to clearly differ from official Watain gear.”

  • The layouts above are mandatory for all members. Pins can only be official Watain pins.

  • All rockers and bar tabs must be black with white "Fette Trump Deutsch” font lettering and Rosso Red border stitching. Bar tabs must measure 3 inches (7.62 cm) x .75 inch (1.91 cm). Watain will only have white bordered patches and Watain Disciples will only have red. NO EXCEPTIONS!

  • The Division patches must follow these guidelines:

    I — Measure 4 inches (10.16 cm) x 2 inches (5.08 cm), unless a different shape is used. In this case, the widest part of the patch can not exceed 4 inches (10.16 cm).

    II — Incorporate imagery of your country or state, such as flag, landmark, etc., as well as Watain and Watain Disciples imagery. Remember that the finished design will only be 4 inches (10.16 cm) x 2 inches (5.08 cm) and stitched to cloth, so be aware that small, fine detail may be lost in translation. (Most patch makers will reply with an alert if the artwork is incompatible.)

    III — Design must be submitted to president@wataindisciplesworldwide.com for approval before actual production.

    IV — The patch must be created by the Division itself, but the design itself (while ideally would be created internally) may be outsourced, so long as it fits the design requirements.

    V — Upon approval, the recommended number to be created would be 25. This number will fluctuate, dependent upon the number of projected initiates, with a surplus for any members who wish to apply. Most patch makers have price breaks at 50 or 100, so plan ahead.

    VI — 12 of these patches must be sent to Disciples Headquarters upon completion, whereupon they will be sent to Watain Headquarters in Uppsala, Sweden.

    VII — Division patches may only be worn by sworn members of each their respective Division.

  • If you would like to create shirts, hoodies or other specialized items for your individual chapter, you may do so, but only under the following guidelines:

    I — All designs must be pre-approved before being produced.

    II — You may only use the colors black, white and Rosso Red.

    III — Do not use the Wolf logo found on the band member’s vests.

    IV — Incorporate one or both of the Watain Disciples logos, as we would like them look unique.

    V — Merch can not be sold to anyone outside of your Division or found on eBay, Etsy, Tradera or similar sites. Anyone found selling their Watain Disciples merchandise outside of the club will have their membership immediately and permanently revoked and you will be placed on the blacklist visible to all members.

    VI — 12 of each must be sent to Disciples Headquarters, where they will be sent to Watain Headquarters in Uppsala, Sweden.

    Shirts and other textiles can be cost prohibitive to ship overseas. We can come up with a plan to ship them straight to Uppsala if not originating in Europe. If sending shirts or hoodies, please provide the following sizes:

    3 MD — 1 LG — 1 XXL

    (Sizes will be subject to change at any time.)

    If you have any questions that are not answered here, send an email to president@wataindisciplesworldwide.com.

Watain Disciples Worldwide | Trident Divider